Sökresultat

Nanowire (NW) arrays containing a top segment of GaxIn1–xP are investigated, comparing NWs grown using two different Ga precursors, trimethylgallium (TMGa) and triethylgallium (TEGa). TMGa is the precursor commonly used for the particle-assisted vapor–liquid–solid (VLS) growth of GaxIn1–xP NWs. However, it shows inefficient pyrolysis at typical NW growth conditions. The use of the alternative prec

Tunnel field-effect transistors (TFETs) are promising candidates that have demonstrated potential for and beyond the 3 nm technology node. One major challenge for the TFETs is to optimize the heterojunction for high drive currents while achieving steep switching. Thus far, such optimization has mainly been addressed theoretically. Here, we experimentally investigate the influence of the source seg

Crustacean copepods in high-latitude lakes frequently alter their pigmentation facultatively to defend themselves against prevailing threats, such as solar ultraviolet radiation (UVR) and visually oriented predators. Strong seasonality in those environments promotes phenotypic plasticity. To date, no one has investigated whether low-latitude copepods, experiencing continuous stress from UVR and pr

OBJECTIVES: Infections with extended spectrum beta-lactamase (ESBL) producing Enterobacteriaceae (EPE) are a major healthcare concern. Our goal was to investigate whether a probiotic mixture could be used for eradication therapy in patients with prolonged intestinal EPE carriage.METHODS: We performed a randomized, placebo-controlled single blinded clinical superiority trial in the south of Sweden

Background and objective: Involvement of pulmonary vascular remodelling is a characteristic sign in COPD. Vascular mediators such as vascular endothelial growth factor (VEGF) and prostacyclin may regulate fibroblast activity. The objective was to study the synthesis of VEGF and interactions with prostacyclin and transforming growth factor (TGF)-β1 in lung fibroblasts from patients with COPD and he

The project shows that the working environment is rarely the sole cause of early retirement, but working environment factors may explain a large fraction of the transition to disability pension in particular. Several working environment predictors of early retirement are well-documented in the Nordic countries, but workplace policies and activities to retain older workers rarely aim to improve the

Aim: This study assessed whether a Swedish school-based exercise intervention programme could increase total physical activity. Methods: We followed up 228 children who started school in 1998-2000 seven years later, when they had reached a mean age of 14.8. The 152 children (59% boys) at the intervention school did 200 minutes of physical education per week during that period, and the 76 children

AIMS: To investigate subjective health complaints (SHCs) (psychological and somatic, respectively) among disabled and non-disabled adolescents, focusing on the impact of traditional bullying and cyber harassment, and furthermore to report psychological and somatic SHCs across different types of disability.METHODS: Data from the public health survey of children and adolescents in Scania, Sweden, 20

The current research focuses in understanding how inlet pressure, EGR, combustion phasing, engine speed and pilot main ratio are affecting the main parameters of the combustion (e.g. efficiency, NOx, soot, maximum pressure rise rate) in the novel concept of injecting high octane number fuels in partially premixed combustion. The influence of the above mentioned parameters was studied by performing

Using alternative fuels like Natural Gas (NG) has shown good potentials on heavy duty engines. Heavy duty NG engines can be operated either lean or stoichiometric diluted with EGR. Extending Dilution limit has been identified as a beneficial strategy for increasing efficiency and decreasing emissions. However dilution limit is limited in these types of engines because of the lower burnings rate of

The behavior of Ethanol and seven fuels in the boiling point range of gasoline but with an Octane Number spanning from 69 to 99 was investigated in Partially Premixed Combustion. A load sweep was performed from 5 to 18 bar gross IMEP at 1300 rpm. The engine used in the experiments was a single cylinder Scania D12. To allow high load operations and achieve sufficient mixing, the compression ratio w

It is tractable to increase the torque for an HCCI engine and one way is to add a turbocharger. Operating in HCCI mode requires accurate control of the combustion phasing, CA50. The higher the engine torque, the narrower the CA50 window becomes where HCCI operation is maintained. As the CA50 varies stochastically between cycles this requires improved CA50 control for turbo HCCI engines. The main f

By using a turbo the operating range of the HCCI engine can be increased, but at the expense of increased controller complexity. The dynamics the turbo introduces in the intake and the exhaust manifolds, have a large impact on the in-cylinder mixture temperature, pressure and finally the combustion phasing. To compensate for this and to maintain desired combustion phasing, precise control of the n

For diesel engines the major exhaust problem is particulate matter and NOx emissions. To reduce NOx, exhaust gas recirculation (EGR) is often used. The behavior of the EGR-level will therefore influence the emissions and it is therefore valuable to keep track of the EGR-level. Especially during transients it is difficult to predict how the EGR-level varies. In this paper the CO2-level in the intak

Partially Premixed Combustion (PPC) is a combustion concept by which it is possible to get low smoke and NOx emissions simultaneously. PPC requires high EGR levels and injection timings sufficiently early or late to extend the ignition delay so that air and fuel mix extensively prior to combustion. This paper investigates the operating region of single injection diesel PPC in a multi cylinder heav

A diesel engine developed for an international market must be able to run on different fuels considering the diesel fuel qualities and the increasing selection of biofuels in the world. This leads to the question of how different fuels perform relative to a standard diesel fuel when not changing the hardware settings. In this study five fuels (Japanese diesel, MK3, EN590 with 10% RME, EN590 with 3

Natural gas and hydrogen enriched natural gas has been tested as fuels together with diesel oil and RME in a single cylinder Scania research engine. The gas was introduced as port injection while the diesel was introduced as early direct injection. Because the gas was premixed with air before combustion and the diesel was injected early in the compression stroke, the engine ran close to HCCI mode.

In HCCI you do not have the same control of the combustion like in SI and Diesel engines. Controlling the start of a combustion event is a difficult task and requires feedback from previous cycles. This feedback can be retrieved from ion current measurements. By applying a voltage over the spark gap, ions will lead a current and a signal that represents the combustion in the cylinder will be retri

Utilization of an ethanol driven, combustion-based power generator promises high-efficiency combustion in diesel-like engines and avoids problems connected to shrinking supplies of fossil fuels since fuels like ethanol or dimethyl ether can be produced from renewable resources. Fuel injection into such generator through a piezoelectric micro mass flow controller (MMFC) features low power consumpti