Filtyp
Introduction: The aim was to assess cost-effectiveness of including pneumococcal vaccination for elderly in a national vaccination programme in Sweden, comparing health-effects and costs of pneumococcal related diseases with a vaccination programme versus no vaccination. Method: We used a single-cohort deterministic decision-tree model to simulate the current burden of pneumococcal disease in Swed
A simple second order feed-forward disturbance attenuation problem is analyzed. The problem has one free parameter, the control weight ρ in the loss function. It is found that controller structure and uniqueness for H∞ - control, in the optimal case, changes when ρ is varied. Sensitivity to initial conditions is also drastically changed. The example is simple enough to allow a solution by formula
INTRODUCTION: Chronic subdural haematomas (CSDHs) are one of the most common neurosurgical conditions. The goal of surgery is to alleviate symptoms and minimise the risk of symptomatic recurrences. In the past, reoperation rates as high as 20%-30% were described for CSDH recurrences. However, following the introduction of subdural drainage, reoperation rates dropped to approximately 10%. The stand
Motivated by the potential of nondiffraction limited, real-time computational image sharpening with neural networks in astronomical telescopes, we studied wavefront sensing with convolutional neural networks based on a pair of in-focus and out-of-focus point spread functions. By simulation, we generated a large dataset for training and validation of neural networks and trained several networks to
Efficient mitigation of power amplifier (PA) nonlinear distortion in multi-user hybrid precoding based broadband mmWave systems is an open research problem. In this article, we carry out detailed signal and distortion modeling in broadband multi-user hybrid MIMO systems, with a bank of nonlinear PAs in each subarray, while also take the inevitable crosstalk between the antenna/PA branches into acc
Smart vehicles are emerging as a possible solution for multiple concerns in road traffic, such as mobility and safety. This work presents radio localization methods based on simultaneous direction of arrival (DOA), time-delay, and range estimation using the SAGE algorithm. The proposed methods do not rely on external sources of information, such as global navigation satellite systems (GNSS). The p
Techniques for accurate, robust and efficient over-the-air testing for devices in the next generation communication system are important. This work aims at presenting the use of an aperture calibration technique, through which field values and power density values are reconstructed at an arbitrary plane in the near-field from a measurement of a separate plane for devices operating in 28-60 GHz. Th
Fundamental bounds on antenna and scattering metrics are presented in this paper utilizing volumetric method of moments. This makes it possible to investigate scenarios not solvable with classical surface method of moments which assumes that good conductors as used. One practical example is the study of plasmonic devices whose operation relies on the interaction between material properties and rad
Objectives: To quantify the effect of secondary screening for hip dislocations. Design: Retrospective analysis of hospital files from participants in a prospectively collected nationwide registry. Setting: Child healthcare centres and orthopaedic departments in Sweden. Participants: Of 126 children with hip dislocation diagnosed later than 14 days age in the 2000-2009 birth cohort, 101 had complet
This research investigated the liquid-phase removal of chloramphenicol (CAP), an emerging contaminant using molecularly imprinted polymers (MIPs). CAP adsorption profiles, equilibrium, and kinetics were analysed. The adsorption performance was compared between MIPs and non-imprinted polymers (NIPs), both with silica or without silica grafting. The imprinting factor (IF) values for the Si@MIPs-CAP
The European Spallation Source Neutrino Super Beam (ESSνSB) project aims at a discovery of leptonic CP violation with a precise measurement of the CP phase angle. ESSνSB is characterized by an intense neutrino beam to be produced at ESS by a 5-MW proton beam, and the placement of the far detector at the second oscillation maximum. The aims of the near detector for ESSνSB are neutrino flux and inte
Fra at være almindelig på Lolland i det 18. århundrede blev Læge-Betonie, (Betonica officinalis), til sidst en af de sjældneste planter i den danske flora. Dens naturlige voksepladser forsvandt, og i 2016 var der kun to blomstrende planter i helelandet, og de stod i en vejgrøft langs Bjerremarkvej i Tågerup sogn noglekilometer øst for Rødby. Vi besluttede at starte et redningsprojekt ved atsamle f
With the broader industrial application of Additive Manufacturing (AM), designers are facing new challenges in conceptual design for AM. To better understand the problematic, the authors organised a design workshop with six experts in AM. The paper presents the results of the conducted design workshop and discusses the current and future trends in research on the conceptual design for AM.
Damage detection systems (DDSs) provide information on the integrity of structural systems in contrast to local information from inspections or non-destructive testing (NDT) techniques. In this paper, an approach is developed that utilizes DDS information to update structural system reliability and integrate this information into risk and decision analyses. The approach includes a novel performanc
Asset integrity and management is an important part of the oil and gas industry especially for existing offshore structures. With declining oil price, the production rate is an important factor to be maintained that makes integrity of the structures one of the main concerns. Reliability based and risk- based inspection (RRBI) constitutes an efficient method to optimize inspection planning. Basing
A technique for enhancing the bandwidth of a broadside tri-modal patch antenna is described. The key idea of the technique is to incorporate a dual-resonance structure into the broadside tri-modal patch geometry. By increasing one edge of the tri-modal patch while decreasing its size at the opposite edge, the resulting structure can be viewed as two super-imposed Y-shaped structures of different r
We present a novel texture compression scheme, called iPACKMAN, targeted for hardware implementation. Interms of image quality, it outperforms the previous de facto standard texture compression algorithms in the majority of all cases that we have tested. Our new algorithm is an extension of the PACKMAN texture compressionsystem, and while it is a bit more complex than PACKMAN, it is still very low
