Filtyp
The development of models that provide accurate spatio-temporal predictions of ambient air pollution at small spatial scales is of great importance for the assessment of potential health effects of air pollution. Here we present a spatio-temporal framework that predicts ambient air pollution by combining data from several different monitoring networks and deterministic air pollution model(s) with
In this paper, we analyze the performance of regularized channel inversion (RCI) precoding in multiple-input single-output (MISO) broadcast channels with confidential messages under transmit-side channel correlation. We derive a deterministic equivalent for the achievable per-user secrecy rate which is almost surely exact as the number of transmit antennas and the number of users grow to infinity
The analysis and design of a millimeter-wave passive balun on silicon substrate with small size and good balance is presented. The reason for the imbalance of the balun is analyzed and a novel method using two grounded T bars beneath the coupled lines to tune the balance is proposed. The balun was fabricated in a 65 nm CMOS process, by using broadside coupled lines with small separation, the lengt
The reassignment technique is used to increase localization for signal components in the time-frequency representation. The technique gives perfect localization for infinite linear chirp-signals, impulses and constant frequency signals but not for short non-stationary signals. In this paper, a scaled reassignment is proposed, based on the spectrogram using a Gaussian window. The resulting reassign
This paper describes the development of a fuzzy inference system (FIS) for emulating an analog joystick using an inductive tongue-computer interface. The principle of operation of the interface and the inductive sensors signals are described. The FIS receives sensor signals and output the Cartesian position of the virtual joystick, which can be used to control the mouse pointer in a personal compu
A state-dependent variable-gain control system is implemented to follow the characteristics of a laboratory-scale up-flow anaerobic fixed-bed reactor dynamically. The transition from one state to another is determined on an hourly basis, depending on difference between the setpoint of the reactor pH and its true value. Considerable improvement of the process stability - reduction of oscillation in
When conducting laser based diagnostics in combustion environments it is often desirable to obtain temporally resolved information. This can be due to several factors such as combustion taking place in a turbulent flow field, flame propagation from a spark plug in an initially quiescent combustible mixture, or rapid, multi-point fuel consumption in a homogeneous charge as a result of compression i
A numerical scheme for a stochastic partial differential equation of heat equation type is considered where the drift is locally bounded and the dispersion may be state dependent. Uniform convergence in probability is obtained.
Abstract in UndeterminedA series of six fully aromatic ionomers with precisely sequenced sulfonated sites along the polymer chains have been designed, prepared and characterized as proton-exchange membranes. Two straight-forward and efficient synthetic strategies based on Ullmann ether reactions and a Baeyer-Villiger rearrangement were devised to obtain bisphenol monomers with four or six phenylen
Matrix assisted laser desorption/ionization time-of-flight mass spectrometry (MALDI-TOF MS) is currently changing the clinical routine for identification of microbial pathogens. One important application is the rapid identification of bacteria for the diagnosis of bloodstream infections (BSI). A novel approach based on acoustic trapping and an integrated selective enrichment target (ISET) microchi
We consider a distribution system consisting of a central warehouse and a group of retailers facing independent stochastic demand. The retailers replenish from the warehouse, and the warehouse from an outside supplier with ample supply. Time is continuous. Most previous studies on inventory control policies for this system have considered stock-based batch-ordering policies. We develop a time-base
Rapid control of bleeding is the key to reducing bleeding complications and thereby preserving joint and musculoskeletal function in haemophilia patients with inhibitors. However, this requires early diagnosis following the onset of bleeding and strategies for rapid treatment in an outpatient setting. Overarching themes on the need for speed in managing bleeds in haemophilia patients were examined
Flavours are biologically active molecules of large commercial interest in the food, cosmetics, detergent and pharmaceutical industry. The production of flavours can take place by either extraction from plant materials, chemical synthesis, through biological conversion of precursor molecules or through de novo biosynthesis. The latter alternatives are gaining importance through the rapidly growing
Being able to orient in the vicinity of the home and independently go shopping or visiting a friend can become increasingly difficult when a person suffers from memory decline. The adaption of traditional navigation apps based on satellite positioning could provide an aid, but there are several questions to investigate related to the design and function of such an app. These questions include how
A cultivation strategy combining the advantages of temperature limitedfed-batch and probing control is presented.This is a suitable way to produce recombinant proteins while minimizing therelease of endotoxins which complicates the downstream processing.The downside with the temperature limited fed-batch technique has been the difficulty to achieve a controlled excess of glucose inthe reactor with
To fulfill increasing requirements within the manufacturing sector, highly flexible and adaptable automation systems are needed. It is desirable to have one integrated approach that stretches from the process planning phase, through the implementation phase and all the way to the phase for execution of the process control logics. One promising approach is to use the concepts of service-oriented ar
