Filetype
During ion sputtering of GaSb(100) surfaces a transient behavior from initial smoothing to roughening accompanied by self-organized pattern formation has been observed using in situ x-ray reflectivity and grazing incidence small angle scattering. The induced patterns show hexagonally ordered nanodot arrays with a spatial periodicity of 30 nm. The correlation length of the pattern increases with io
We demonstrate an X-ray coherent imaging method that combines high spatial resolution with the ability to map grains within thick polycrystalline specimens. An X-ray objective serves to isolate an embedded grain. Iterative oversampling routines and Fourier synthesis are used to reconstruct the shape and strain field from the far-field intensity pattern. In a demonstration experiment a ∼500-nm Pt g
The 2015 Paris Agreement aims to strengthen the global response to climate change, and to maintain an average global temperature well below 2°C, with aspirations toward 1.5°C, by means of balancing sources and sinks of greenhouse gas emissions. Following this, the importance of carbon dioxide removal in global emission pathways has been further emphasized, and Negative Emissions Technologies (NETs
In this work, we describe the synthesis of CdS nanocrystals in thin polymeric films by in-situ Grazing Incidence Diffraction (GID) and Grazing Incidence Small Angle Scattering (GISAXS). The 2D GISAXS patterns indicate how the precursor structure is altered as the temperature is varied from 25°C to 300°C. At 150°C, the CdS nanocrystals start to arrange themselves in a hexagonal lattice with a latti
Hard X-ray lens-less microscopy raises hopes for a non-invasive quantitative imaging, capable of achieving the extreme resolving power demands of nanoscience. However, a limit imposed by the partial coherence of third generation synchrotron sources restricts the sample size to the micrometer range. Recently, X-ray ptychography has been demonstrated as a solution for arbitrarily extending the field
The possibility to investigate complex magnetic profiles throughout an ultrathin magnetic film or an interface by soft x-ray resonant magnetic reflectivity is presented. The determination of in- and out-of-plane magnetic profile is shown to be possible with a subnanometer resolution by measuring the reflectivity over a wide angular range. The technique is applied to a granular magnetic multilayer
Polymers such as benzocyclobutene are commonly used as embedding materials for semiconductor nanostructures. During the curing process of the polymer up to 250 °C, a significant impact of strain can be induced on the embedded semiconductor material due to different thermal expansion coefficients. This strain has been revealed by X-ray diffraction in free-standing GaAs nanowires grown on a silicon
In this work, selective area growth has been used for the realization of InP based photonic integrated circuits (PICs). To predict the strain, thickness and bandgap energy variations over large and high-density multifunctional arrays, it is necessary to precisely design the shapes and positions of the dielectric masks by computational modeling. To address the mask layout density and complexity in
Parental care can be partitioned into traits that involve direct engagement with offspring and traits that are expressed as an extended phenotype and influence the developmental environment, such as constructing a nursery. Here, we use experimental evolution to test whether parents can evolve modifications in nursery construction when they are experimentally prevented from supplying care directly
This paper reports the latest improvements performed on structural characterization by high resolution x-ray diffraction (XRD) on InGaAlAs-based multiple quantum well (MQW) structures on InP substrates, produced by metal organic vapor phase epitaxy in the regime of selective area growth (SAG). A new diffractometer, with a sub-millimeter x-ray spot, was used in the laboratory to study the MQW prope
Grazing-incidence X-ray diffraction measurements on single GaAs nanowires (NWs) grown on a (111)-oriented GaAs substrate by molecular beam epitaxy are reported. The positions of the NWs are intentionally determined by a direct implantation of Au with focused ion beams. This controlled arrangement in combination with a nanofocused X-ray beam allows the in-plane lattice parameter of single NWs to be
We have built a new small furnace to perform high temperature studies up to 1200°C in vacuum or in oxygen atmosphere. This furnace was originally used as a catalytic reactor optimized for the in situ X-ray Absorption Spectroscopy experiments on beamline ID24. It has now been redesigned for use on the ESRF beamline ID01 for in situ Grazing Incidence Small Angle X-ray Scattering experiments. For the
The properties of nanoscale materials vary with the size and shape of the building blocks, which can be measured by (grazing-incidence) small-angle X-ray scattering along with the mutual positions of the nanoparticles. The accuracy in the determination of such parameters is dependent on the signal-to-noise ratio of the X-ray scattering pattern and on the visibility of the interference fringes. Her
Radiocarbon (14C), as a consequence of its production in the atmosphere and subsequent dispersal through the carbon cycle, is a key tracer for studying the Earth system. Knowledge of past 14C levels improves our understanding of climate processes, the Sun, the geodynamo, and the carbon cycle. Recently updated radiocarbon calibration curves (IntCal20, SHCal20, and Marine20) provide unprecedented ac
The 2015 Paris Agreement specified that the goal of international climate policy is to strengthen the global response to climate change by restricting the average global warming this century to “well below” 2°C above pre-industrial levels and to pursue efforts to limit it to 1.5°C. In this context, “Negative Emissions Technologies” (NETs)—technologies that remove additional greenhouse gases (GHGs)
We investigated the growth of CdS nanoparticles in polymer films by means of ex-situ and in-situ x-ray scattering experiments using synchrotron radiation. The CdS nanoparticles were synthesized by thermal decomposition of a Cd thiolate precursor dispersed in a cyclic olefin copolymer. The films were deposited by spin coating. Grazing incidence diffraction (GID) reveals the Bragg reflections of the
There is currently interest in low strain HPHT diamond due to its expected application as various types of X-ray optical elements at Synchrotrons, where the X-ray intensity is becoming progressively too severe for the existing materials. The diamond crystals need to be synthesised with unprecedented lattice quality. In recent measurements at the ID19 beamline of European Synchrotron Radiation Faci
We describe in this paper the performance under synchrotron radiation of a sealed gaseous detector, Vantec-1, operating at high pressure and less prone to discharges. It is consequently operating at high gain (>105) at high local counting rates up to 106 cps/mm2. To achieve these characteristics, a thin resistive layer is used on a glass plate between the mesh and the readout anode. The performanc
Structural and transport properties of (Bi2Sr2CuO6+δ)m/(CaCuO 2)n superconducting multilayers, obtained by molecular beam epitaxy (MBE) alternately stacking m layers of Bi2Sr2CuO6+δ with n layers of CaCuO2, have been studied. Resistivity measurements and I-V characteristics in perpendicular and parallel magnetic fields have allowed to estimate the anisotropy parameter which results very low with r
High quality single-crystal synthetic diamond is the most suitable material for selected X-ray optical applications in the latest generation X-ray light sources. Excellent heat handling properties, as well as low absorption, coupled with high perfection in the crystal bulk and very good surface quality, are crucial for such applications. In recent years, some progress has been made in the fields o
