Search results

Filter

Filetype

Your search for "*" yielded 530017 hits

Electrocardiogram (ECG) Signal Processing

Signal processing of electrocardiographic signals has a long and rich history and has greatly helped to enhance the diagnostic capability, especially when signals are recorded in noisy environments. This article gives an introductory presentation of the basic set of algorithms used for conditioning the ECG with respect to different types of noise and artifacts, detecting heartbeats, extracting bas

Model-Based Estimation of Cylinder Pressure Sensor Offset using Least-Squares Methods

Two methods for estimating the sensor offset of a cylinder pressure transducer are developed. Both methods fit the pressure data during pre-combustion compression to a polytropic curve. The first method assumes a known polytropic exponent, and the other estimates the polytropic exponent. The first method results in a linear least-squares problem, and the second method results in a nonlinear least-

Heat induced aggregation of b-lactoglobulin studied by dynamic light scattering

The in situ heat-induced aggregation of commercial β-lactoglobulin as such, or after further purification, was followed to a z-average hydrodynamic diameter of 15–20 nm at 59–63 °C by dynamic light scattering. In this temperature range, measurable increase of hydrodynamic diameter occurred after an apparent lag period, which was strongly dependent on heating temperature, pH and initial protein con

Partial Response and Faster-than-Nyquist Signaling

Bandwidth efficiency is a key objective in the design of a digital communication system. Traditionally it is accomplished by increasing the constellation size of the signaling system. In this thesis alternative techniques are studied. Because the communication channel is continuous, so must the actual time signals be. Therefore the construction of the continuous signals is included in the code des

Augmented Heat Transfer Of An Internal Blade Tip Wall With Pin-Fins

The heat transferred to the turbine blade is substantially increased as the turbine inlet temperature is increased. Cooling methods are therefore much needed for the turbine blades to ensure a long durability and safe operation. The blade tip region is exposed to the hot gas flows. A common way to cool the tip is to use serpentine passages with 180-deg turn under the blade tip cap taking advantage

Method for describing and analysing cascading effects in past events: Initial conclusions and findings

Knowledge about the nature, processes and patterns of cascading effects, i.e. where infrastruc-ture dependencies lead to impacts propagating from one system to other systems, is essential in order to miti-gate and respond to crises that involve critical infrastructures and societal functions. This paper presents a method for systematic description of cascading effects in past event, to some extent

Observer-Based Impedance Control in Robotics

This paper presents theoretical and experimental results on observer-based impedance control. Impedance control is a technique for robot force control, which is often used to deal with geometric uncertainty. The aim of this technique is to obtain a dynamic relation between position and force in interaction similar to Newton's second law. Here the velocity is used to modify the damping of the imped

Scandoromani : Remnants of a mixed language

Scandoromani: Remnants of a Mixed Language is the first, comprehensive, international description of the language of the Swedish and Norwegian Romano, also labeled resande/reisende. The language, an official minority language in Sweden and Norway, has a history in Scandinavia going back to the early 16th century. A mixed language of Romani and Scandinavian, it is spoken today by a vanishingly smal

Strategic growth of industrial design consultancy: a study of changes in ID consultancy in a post-industrial society I

Based on a study of Swedish and Finnish industrial design consultancies (IDCs) we discuss how changes in industry have affected id-consultancies cope with growth, organizational and management issues. The traditional industrial designer worked in a small consultancy mainly with clients focusing on mass-produced products. The clients were basically domestic even if they operated worldwide. Investme